Bauble is a Hack Club YSWS program where you 3D model an ornament, and you get it printed out put on Oscar, the tree at Hack Club’s HQ in Vermont! After the tree gets taken down, you'll receive your ornament in the mail!

Design a 3D model of an ornament! It can be whatever you want, as long as it’s appropriate and is under 100 x 100 x 100 mm. You have to make it yourself, models downloaded off of the internet are not allowed.

Time tracking is not required. You may track time with Lapse if you wish, but it is not necessary.

Your ornament must:

• Be modeled by you;
• Be in STL format;
• Be uploaded to Printables;
• Have a hole of a minimum 5mm diameter or some other way a hook or string could be attached;
• Be no larger than 100 x 100 x 100 mm in all directions;
• Be appropriate, and;
• Be able to print without supports.

If you have any other questions about requirements, ask in the #bauble channel in the Slack!

After the tree is taken down, your ornament will be packaged up and shipped out to you from HQ!

No, Bauble cannot be double dipped with any other Hack Club programs.

Great! Make sure it follows all the requirements (see the requirements section above), upload it to Printables, and submit!

Ask in the #bauble channel in the Slack!